Reference Guide

identifies that this patch applies to Dell Networking OS version 7.8.1.0 — E-Series
platform, for RP2, addressing the layer 2 management process, and this patch is
the first version of this patch.
There is no need to reload or reboot the system when you insert the patch. The In-
Service Modular patch replaces the existing process code. After installation is
complete, the system executes the patch code as though it was always there.
Related
Commands
show patch — displays the system patches loaded with the in-service modular
hot fix command.
process restartable
Enable a process to be restarted. Restartability is subject to a maximum restart limit. This limit is defined
as a configured number of restarts within a configured amount of time. On the software exception that
exceeds the limit, the system reloads (for systems with a single RPM) or fails over (for systems with dual
RPMs).
S4820T
Syntax
process restartable [process] [count number] [period minutes]
Parameters
process Configure a process to be restartable.
count number Enter the number of times a process can restart within the
configured period. The range is from 1 to 3. The default is 3.
period minutes Enter the amount of time within which the process can
restart count times. The range is from 1 to 60 minutes. The
default is 60 minutes.
Default By default, a process can be restarted a maximum of three times within one hour.
On the exception that exceeds this limit, the system reloads or fails over.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.4.1.0 Introduced on the E-Series.
696
High Availability (HA)