Reference Guide

The S-Series does not generate log messages is generated when the link flaps
down/up during TDR tests.
Related
Commands
show tdr — displays the results of the TDR test.
show tdr
Display the TDR test results.
S4820T
Syntax
show tdr interface
Parameters
interface Enter the keyword GigabitEthernet then the slot/port
information for the 100/1000 Ethernet interface.
Defaults none
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 6.1.1.0 Introduced.
Usage
Information
If the TDR test has not been run, an error message is generated:
%Error: Please run the TDR test first
The following describes the TDR test status.
Status Definition
OK Status:
Terminated
TDR test is complete, no fault is detected on the cable, and
the test is terminated.
Interfaces
817