Reference Guide

Version 8.3.11.0 Introduced on the Z9000.

Version 8.3.7.0 Introduced on the S4810.

Usage

Information

You must save the configuration and reload the system to implement ASF. When

you enter the command, the system sends a message stating that the new mode is

enabled when the system reloads.

cam-acl

Allocate content addressable memory (CAM) for IPv4 and IPv6 ACLs.

S4820T

Syntax

Parameters

default Use the default CAM profile settings and set the CAM as

follows:

• L3 ACL (ipv4acl): 4

• L2 ACL(l2acl): 6

• IPv6 L3 ACL (ipv6acl): 0

• L3 QoS (ipv4qos): 2

• L2 QoS (l2qos): 1

• OpenFlow: 0 (disabled)

• FCoE (fcoeacl): 0 (disabled)

• iSCSI Optimization (iscsioptacl): 0 (disabled)

Allocate space to each CAM region.

Enter the CAM profile name then the amount of CAM space

to be allotted. The total space allocated must equal 13. The

ipv6acl range must be a factor of 2.

Enter 4 or 8 for the number of OpenFlow FP blocks.

• 4: Creates 242 entries for use by the OpenFlow controller

(256 total entries minus the 14 entries reserved for

internal functionality)

• 8: Creates 498 entries for use by the OpenFlow controller

(512 total entries minus the 14 entries reserved for

internal functionality)

Using the fcoe parameter, enter the number of FP groups to

be allocated for FCoE transit. Enter 1 – 6; maximum six

groups. Each group has 128 entries, creating a total of 768

possible entries for FCoE FP groups. The value given must be

an even number.

Control and Monitoring