Users Guide
VRRP for IPv6 Conguration
This section shows VRRP IPv6 topology with CLI congurations.
Consider an example VRRP for IPv6 conguration in which the IPv6 VRRP group consists of two routers.
Figure 153. VRRP for IPv6 Topology
NOTE
: This example does not contain comprehensive directions and is intended to provide guidance for only a typical VRRP
conguration. You can copy and paste from the example to your CLI. Be sure you make the necessary changes to support your
own IP addresses, interfaces, names, and so on.
NOTE: In a VRRP or VRRPv3 group, if two routers come up with the same priority and another router already has MASTER
status, the router with master status continues to be master even if one of two routers has a higher IP or IPv6 address.
Router 2
R2(conf)#interface tengigabitethernet 1/1
R2(conf-if-te-1/1)#no ip address
Virtual Router Redundancy Protocol (VRRP)
1051