Users Guide

By default the total available buer for PFC is 6.6 MB and when you congure dynamic ingress buering, a minimum of least 52 KB per
queue is used when all ports are congested. By default, the system enables a maximum of two lossless queues on the S4820T platform.
This default behavior is impacted if you modify the total buer available for PFC or assign static buer congurations to the individual PFC
queues.
Behavior of Tagged Packets
The below is example for enabling PFC for priority 2 for tagged packets. Priority (Packet Dot1p) 2 will be mapped to PG6 on PRIO2PG
setting. All other Priorities for which PFC is not enabled are mapped to default PG – PG7.
Classication rules on ingress (Ingress FP CAM region) matches incoming packet-dot1p and assigns an internal priority (to select queue as
per Table 1 and Table 2).
The internal Priority assigned for the packet by Ingress FP is used by the memory management unit (MMU) to assign the packet to right
queue by indexing the internal-priority to queue map table (TABLE 1) in hardware.
PRIO2COS setting for honoring the PFC protocol packets from the Peer switches is as per above Packet-Dot1p->queue table (Table 2).
The packets come in with packet-dot1p 2 alone are assign to PG6 on ingress.
The packets come in with packet-dot1p 2 alone use Q1 (as per dot1p to Queue classication – Table 2) on the egress port.
• When Peer sends a PFC message for Priority 2, based on above PRIO2COS table (TABLE 2), Queue 1 is halted.
• Queue 1 starts buering the packets with Dot1p 2. This causes PG6 buer counter to increase on the ingress, since P-dot1p 2 is
mapped to PG6.
• As the PG6 watermark threshold is reached, PFC generats for dot1p 2.
Conguration Example for DSCP and PFC Priorities
Consider a scenario in which the following DSCP and PFC priorities are necessary:
DSCP
0 – 5, 10 - 15 20 – 25, 30 – 35
Expected PFC
Priority
1 2
To congure the aforementioned DSCP and PFC priority values, perform the following tasks:
1 Create class-maps to group the DSCP subsets
class-map match-any dscp-pfc-1
match ip dscp 0-5,10-15
!
class-map match-any dscp-pfc-2
match ip dscp 20-25,30-35
2 Associate above class-maps to Queues Queue assignment as below.
NOTE
: Although, each port on the S4810, S4820T, and S5000 devices support 8 QoS queues, you can congure only 4
QoS queues (0-3)to manage data trac. The remaining 4 queues (4-7) are reserved for control trac.
Table 17. Queue Assignments
Internal-
priority
0 1 2 3 4 5 6 7
Queue 0 0 0 1 2 3 3 3
254 Data Center Bridging (DCB)