Users Guide

View Conguration Files
Conguration les have three commented lines at the beginning of the le, as shown in the following example, to help you track the last
time any user made a change to the le, which user made the changes, and when the le was last saved to the startup-conguration.
In the running-conguration le, if there is a dierence between the timestamp on the “Last conguration change” and “Startup-cong last
updated,” you have made changes that have not been saved and are preserved after a system reboot.
Example of the show running-config Command
Dell#show running-config
Current Configuration ...
! Version 9.4(0.0)
! Last configuration change at Tue Mar 11 21:33:56 2014 by admin
! Startup-config last updated at Tue Mar 11 12:11:00 2014 by default
!
<output truncated for brevity>
Managing the File System
The Dell Networking system can use the internal Flash, external Flash, or remote devices to store les.
The system stores les on the internal Flash by default but can be congured to store les elsewhere.
To view le system information, use the following command.
• View information about each le system.
EXEC Privilege mode
show file-systems
The output of the show file-systems command in the following example shows the total capacity, amount of free memory, le
structure, media type, read/write privileges for each storage device in use.
Dell#show file-systems
Size(b) Free(b) Feature Type Flags Prefixes
520962048 213778432 dosFs2.0 USERFLASH rw flash:
127772672 21936128 dosFs2.0 USERFLASH rw slot0:
- - - network rw ftp:
- - - network rw tftp:
- - - network rw scp:
You can change the default le system so that le management commands apply to a particular device or memory.
To change the default directory, use the following command.
• Change the default directory.
EXEC Privilege mode
cd directory
Enabling Software Features on Devices Using a
Command Option
The capability to activate software applications or components on a device using a command is supported on this platform.
Starting with Release 9.4(0.0), you can enable or disable specic software features or applications that need to run on a device by using a
command attribute in the CLI interface. This enables eective, streamlined management and administration of applications and utilities that
run on a device. You can employ this capability to perform an on-demand activation, or turn-o a software component or protocol. A
Getting Started
53