Users Guide

show lldp neighbors
Display LLDP neighbor information for all interfaces or a specified interface.
S4820T
Syntax
show lldp neighbors [interface interface] [detail]
Parameters
interface interface (OPTIONAL) Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
detail (OPTIONAL) Enter the keyword detail to display all the TLV information, remote
management IP addresses, timers, and LLDP tx and rx counters.
Defaults None
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.1.(0.0) Modified output of detail parameter to display remote management IP addresses.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information Omitting the keyword detail displays only the remote chassis ID, Port ID, and Dead Interval.
Example
R1(conf-if-te-1/31)# do show lldp neighbors
Loc PortID Rem Host Name Rem Port Id Rem Chassis Id
--------------------------------------------------------------
Link Layer Discovery Protocol (LLDP) 1018