Users Guide

Version Description
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
E-Series legacy
command
Usage Information
After you enable multicast, you can enable IGMP and PIM on an interface. In INTERFACE mode, enter the
ip pim sparse-mode command to enable IGMP and PIM on the interface.
Related
Commands
• ip pim sparse-mode — enable IGMP and PIM on an interface.
show ip mroute
View the multicast routing table.
Syntax
show ip mroute [vrf vrf-name] [static | group-address [source-address] | count
| snooping [vlan vlan-id] [group-address [source-address]] | summary | vlt
[group-address [source-address] | count]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to configure
this setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default
VRF.
static (OPTIONAL) Enter the keyword static to view static multicast routes.
group-address
[source-address]
(OPTIONAL) Enter the multicast group-address to view only routes associated
with that group. Enter the source-address to view routes with that group-address
and source-address.
count (OPTIONAL) Enter the keyword count to view the number of multicast routes and
packets.
snooping [vlan
vlan-id] [group-
address [source-
address]]
Enter the keyword snooping to display information on the multicast routes PIM-
SM snooping discovers.
Enter a VLAN ID to limit the information displayed to the multicast routes PIM-SM
snooping discovers on a specified VLAN. The VLAN ID range is from 1 to 4094.
Enter a multicast group address and, optionally, a source multicast address in
dotted decimal format (A.B.C.D) to limit the information displayed to the multicast
routes PIM-SM snooping discovers for a specified multicast group and source.
summary (OPTIONAL) Enter the keyword summary to view a summary of all routes.
Multicast 1072