Users Guide

• track ip route reachability – configure object tracking on the reachability of an IPv4 route.
show track
Display information about tracked objects, including configuration, current tracked state (UP or DOWN), and the clients which
are tracking an object.
Syntax
show track [object-id [brief] | interface [brief] [vrf vrf-name] | ip route
[brief] [vrf vrf-name] | resolution | vrf vrf-name [brief] | brief]
Parameters
object-id (OPTIONAL) Display information on the specified tracked object. The range is 1 to
500.
interface (OPTIONAL) Display information on all tracked interfaces (Layer 2 and IPv4 Layer
3).
ip route (OPTIONAL) Display information on all tracked IPv4 routes.
resolution (OPTIONAL) Display information on the configured resolution values used to scale
protocol-specific route metrics. The range is 0 to 255.
brief (OPTIONAL) Display a single line summary of the tracking information for a
specified object, object type, or all tracked objects.
vrf vrf-name (OPTIONAL) E-Series only: Display information on only the tracked objects that
are members of the specified VRF instance. The maximum is 32 characters. If you
do not enter a VRF name, information on the tracked objects from all VRFs
displays.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Usage Information The following describes the show track command shown in the Example below.
Output Description
Track object-id Displays the number of the tracked object.
Interface type
slot/port, IP route
ip-address, IPv6
route ipv6-
address
Displays the interface type and slot/port number or address of the IPv4/IPv6 route
that is being tracked.
Object Tracking 1096