Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4820T

1091

Configure the UP and DOWN thresholds for each tracked route with the threshold metric command.

The default UP threshold is 254; the default DOWN threshold is 255. The notification of a change in the

state of a tracked object is sent when a metric value crosses a configured threshold.

The tracking process uses a protocol-specific resolution value to convert the actual metric in the routing

table to a scaled metric in the range 0 to 255. You can configure the resolution value used to scale route

metrics for supported protocols with the track resolution ip route and track resolution

ipv6 route

commands.

Commands

• track ip route metric threshold – configure object tracking on the threshold of an IPv4 route metric.

• track resolution ip route – configure the protocol-specific resolution value used to scale an IPv4

route metric.

track interface ip routing

Configure object tracking on the routing status of an IPv4 Layer 3 interface.

Syntax

track object-id interface interface ip routing

To return to the default setting, use the no track object-id command.

Parameters

object-id Enter the ID number of the tracked object. The range is 1 to 500.

interface Enter one of the following values:

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet

then the slot/port information.

• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the

slot/port information.

• For a Loopback interface, enter the keyword loopback then a number from 0

to 16383.

• For a port channel interface, enter the keywords port-channel then a

number.

• For a tunnel interface, enter the keyword tunnel.

• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

Defaults None

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

Version Description

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON. Added support for tunnel interface.

8.3.12.0 Introduced on the S4810.

8.4.1.0 Introduced.

Object Tracking 1099