Users Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4820T

1201

• Passive — passive system does not initiate a session. It only responds to a

request for session initialization from the active system.

The default is Active.

Defaults See Parameters.

Command Modes INTERFACE

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.

Version Description

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.2.0.0 Introduced on the Z9000, S4820T, and S4810.

Usage Information

This command provides the flexibility to fine-tune the timer values based on individual interface needs

when you configure ipv6 ospf BFD in CONFIGURATION mode. Any timer values specified with this

command overrides timers set using the bfd all-neighbors command. Using the no form of this

command does not disable BFD if you configure BFD in CONFIGURATION mode.

To disable BFD on a specific interface while you configure BFD in CONFIGURATION mode, use the

keyword disable.

ipv6 ospf cost

Explicitly specify the cost of sending a packet on an interface.

S4820T

Syntax

ipv6 ospf interface-cost

Parameters

interface-cost

Enter a unsigned integer value expressed as the link-state metric. The range is

from 1 to 65535.

Defaults Default cost based on the bandwidth.