Users Guide

Version Description
7.5.1.0 Introduced on the C-Series.
E-Series Original command.
Usage Information
If you use only the reload command, the system boots into the Dell Networking OS.
If there is a change in the running configuration, the system prompts you to save the new configuration
when you reload the system using the reload command. You can also save your running configuration
manually using the
copy running-config command.
You can use the conditional parameter if any configuration changes made to the NVRAM, such as,
stack-group and fanout configurations, must be saved.
send
Send messages to one or all terminal line users.
Syntax
send [*] | [line ] | [console] | [vty]
Parameters
* Enter the asterisk character * to send a message to all tty lines.
line Send a message to a specific line. The range is from 0 to 11.
console Enter the keyword console to send a message to the primary terminal line.
vty Enter the keyword vty to send a message to the virtual terminal.
Defaults none
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Control and Monitoring 122