Users Guide

Version Description
pre- 6.2.1.1 Introduced on the E-Series.
Usage Information To enable RIP, assign a network address using the network command.
Example
Dell(conf)# router rip
Dell(conf-router_rip)#
Related
Commands
• network — enables RIP.
• exit — returns to CONFIGURATION mode.
show config
Display the changes you made to the RIP configuration. The default values are not shown.
S4820T
Syntax
show config
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Example
Dell(conf-router_rip)# show config
!
router rip
network 172.31.0.0
passive-interface TenGigabitEthernet 1/1
Dell(conf-router_rip)#
Routing Information Protocol (RIP) 1369