Users Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810. Added support for source-interface for link-local IPv6
addressing.
8.3.11.1 Introduced on the Z9000.
8.2.1.0 Introduced on the E-Series (IPv6). Increased the number of VLANs to 4094 (was
2094).
8.1.1.0 Introduced on the E-Series (IPv4).
7.9.1.0 Introduced VRF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series and added support for IPv6 address on the E-Series
only.
Usage Information
The VRF configured using this command has a higher precedence than a VRF configured using the ip
telnet vrf vrf-name command. If you do not use the VRF attribute in this command, then TELENT
client uses the VRF configured using the
ip telnet vrf vrf-name command.
The source interface configured using this command has a higher precedence than the source interface
configured using the ip telnet source-interface command. If you do not configure a source
interface using this command, then the TELNET client uses the source interface configured using the
ip
telnet source-interface command.
In case there is a mismatch between the VRF telnet source interface and the telnent VRF, then an error is
reported.
Example
Dell# telnet vrf vrf1 10.10.10.2
telnet-peer-stack-unit
Open a Telnet connection to the peer stack unit.
Syntax
telnet-peer-stack-unit
Defaults Not configured.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
Control and Monitoring 147