Users Guide

Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced S-Series Stacking.
8.1.1.0 Introduced on the E-Series.
7.7.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information sFlow is disabled by default. In addition to this command, sFlow needs to be enable on individual
interfaces where sFlow sampling is desired.
Related
Commands
• sflow enable (Interface) — enable sFlow on interfaces.
sflow ingress-enable
Enable sFlow ingress on interfaces.
Syntax
sflow ingress-enable
To disable sFlow, use the no sflow ingress enable command.
Defaults Disabled.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S-Series, Z-Series, and MXL switch.
9.2(1.0) Introduced on the Z9500.
Usage Information When you enable ingress sFlow on an interface, flow sampling is done on any incoming traffic.
NOTE: After a physical port is a member of a LAG, it inherits the sFlow configuration from the LAG
port.
Related
Commands
• sflow enable (Global) — turn sFlow globally.
sFlow 1509