Users Guide

Version Description
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information To enable this snmp-server trap-source command, configure an IP address on the interface and
enable the interface configured as an SNMP trap source.
Related
Commands
• snmp-server community — sets the community string.
snmp-server user
Configure a new user to an SNMP group.
Syntax
snmp-server user name {group_name remote ip-address vrf vrf-name udp-port port-
number} [1 | 2c | 3] [encrypted] [auth {md5 | sha} auth-password] [priv {des56
| aes128} priv password] [access access-list-name | ipv6 access-list-name |
access-list-name ipv6 access-list-name]
To remove a user from the SNMP group, use the no snmp-server user name {group_name
remote ip-address vrf vrf-name udp-port port-number} [1 | 2c | 3] [encrypted]
[auth {md5 | sha} auth-password] [priv {des56 | aes128} priv password] [access
access-list-name | ipv6 access-list-name | access-list-name ipv6 access-list-
name] command.
Parameters
name Enter the name of the user (not to exceed 20 characters), on the host that
connects to the agent.
group_name Enter a text string (up to 20 characters long) as the name of the group. The
following groups are created for mapping to read/write community/security-
names (defaults):
• v1v2creadu — maps to a community with ro permissions.
• 1v2cwriteu — maps to a community rw permissions.
remote ip-address Enter the keywords udp-port then the user datagram protocol (UDP) port
number on the remote device. The range is from 0 to 65535. The default is 162.
vrf vrf-name Enter the keywords vrf and then the name of the VRF this is used to connect to
the SNMP server.
NOTE: Use this attribute to specify a VRF name that is used to connect to
the remote host. If no VRF is specified, then the default VRF is used.
udp-port port-
number
Enter the keywords udp-port then the UDP (User Datagram Protocol) port
number on the remote device. The range is from 0 to 65535. The default is 162.
1 | 2c | 3 (OPTIONAL) Enter the security model version number (1, 2c, or 3):
• 1 is the least secure version.
• 3 is the most secure of the security modes.
• 2c allows transmission of informs and counter 64, which allows for integers
twice the width of what is normally allowed.
Simple Network Management Protocol (SNMP) and Syslog 1535