Users Guide

To disable logging, use the no logging command.
Parameters
ip-address Enter the IPv4 address in dotted decimal format.
ipv6-address Enter the IPv6 address in the x:x:x:x::X format.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
hostname Enter the name of a host already configured and recognized by the switch.
udp Enter the keyword udp to enable transmission of log message over UDP followed
by port number. The default port is 514
tcp Enter the keyword tcp to enable transmission of log message over TCP followed
by port number.
vrf vrf-name (Optional) Enter the keyword vrf and then the name of the VRF to enable the
logging process in VRF mode.
NOTE: Use this attribute to specify the VRF that is used to contact the
host. By default, the default VRF is used.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Added udp and tcp keywords for the Z9500.
9.5(0.0) Added udp and tcp keywords for the S4810, S4820T, S6000, Z9000, and MXL.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in
Programmable-Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.4.1.0 Added support for IPv6.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Simple Network Management Protocol (SNMP) and Syslog 1546