Users Guide

0/51 2/49 24 up up
1/49 0/49 12 up up
1/50 2/51 12 up up
2/49 0/51 24 up up
2/51 1/50 12 up up
2/52 12 up down
Dell#
Example (Status)
Dell# show system stack-ports status
Topology: Ring
Interface Link Speed Admin Link
(Gb/s) Status Status
----------------------------------------
0/49 12 up up
0/50 12 up down
0/51 24 up up
1/49 12 up up
1/50 12 up up
2/49 24 up up
2/51 12 up up
2/52 12 up down
Dell#
Example
(Topology)
Dell# show system stack-ports topology
Topology: Ring
Interface Connection
----------------------
0/49 1/49
0/50
0/51 2/49
1/49 0/49
1/50 2/51
2/49 0/51
2/51 1/50
2/52
Dell#
Related
Commands
• reset stack-unit – resets the designated stack member.
• show hardware stack-unit – displays the data plane or management plane input and output statistics
of the designated component of the designated stack member.
• show system (S-Series and Z-Series) – displays the current status of all stack members or a specific
member.
stack-unit priority
Configure the ability of a switch to become the management unit of a stack.
Syntax
stack-unit stack-number priority priority-value
Parameters
stack-number Enter the stack member unit identifier.
priority-value This preference parameter allows you to specify the management priority of one
backup switch over another, with 1 as the lowest priority and 14 being the highest.
The switch with the highest priority value is chosen to become the management
unit if the active management unit fails or on the next reload.
Defaults 1
Command Modes CONFIGURATION
Stacking 1576