Users Guide

To disable the Spanning Tree group, use the no protocol spanning-tree stp-id command.
Parameters
stp-id Enter zero (0). Dell Networking OS supports one spanning tree group, group 0.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information STP is not enabled when you enter SPANNING TREE mode. To enable STP globally on the switch, use the
no disable command from SPANNING TREE mode.
Example
Dell(conf)# protocol spanning-tree 0
Dell(config-stp)#
Related
Commands
• disable — disables spanning tree group 0. To enable spanning tree group 0, use the no disable
command.
show config
Display the current configuration for the mode. Only non-default values display.
Syntax
show config
Command Modes SPANNING TREE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Spanning Tree Protocol (STP) 1597