Users Guide

Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
7.6.1.0 Introduced on the S-Series (S50 only).
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information
If you disable the interface, the cost value is subtracted from the priority value and forces a new MASTER
election if the priority value is lower than the priority value in the BACKUP virtual routers.
version
Set the VRRP protocol version for the IPv4 group.
Syntax
version {2 | 3 | both}
To return to the default setting, use the no version command.
Parameters
2 Enter the keyword 2 to specify VRRP version 2 as defined by RFC 3768, Virtual
Router Redundancy Protocol.
3 Enter the keyword 3 to specify VRRP version 3 as defined by RFC 5798, Virtual
Router Redundancy Protocol.
both Enter the keyword both for in-service migration from VRRP version 2 to VRRP
version 3.
Defaults 2
Command Modes VRRP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.5(0.0) Introduced on the Z9000, S6000, S4820T, S4810, and MXL.
Virtual Router Redundancy Protocol (VRRP) 1730