Users Guide

To remove this filter, you have two choices:
• Use the no seq sequence-number command if you know the filter’s sequence number.
• Use the no deny udp {source mask | any | host ip-address} {destination mask |
any | host
ip-address} command.
Parameters
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified
in A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the filter.
host ip-address Enter the keyword host then the IP address to specify a host IP address.
dscp Enter this keyword dscp to deny a packet based on the DSCP value. The range is
from 0 to 63.
operator (OPTIONAL) Enter one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two ports for the port
command)
port port
Enter the application layer port number. Enter two port numbers if using the range
logical operand. The range is from 0 to 65535.
destination Enter the IP address of the network or host to which the packets are sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified
in A.B.C.D format, may be either contiguous or non-contiguous.
count (OPTIONAL) Enter the keyword count to count packets processed by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by the filter.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL
entry. The range is from 0 to 254 (where 0 is the highest priority and 254 is the
lowest; lower-order numbers have a higher priority) If you did not use the
keyword order, the ACLs have the lowest order by default (255).
fragments Enter the keyword fragments to use ACLs to control packet fragments.
no-drop Enter the keywords no-drop to match only the forwarded packets.
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Access Control Lists (ACL) 201