Users Guide

Version Description
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information You can assign one ingress ACL and one egress ACL (standard or extended) to an interface.
Related
Commands
• mac access-list standard — configure a standard MAC ACL.
• mac access-list extended — configure an extended MAC ACL.
show mac access-lists
Display all of the Layer 2 ACLs configured in the system, whether or not they are applied to an interface, and the count of
matches/mismatches against each ACL entry displayed.
Syntax
show mac access-lists [access-list-name] [interface interface] [in | out]
Parameters
access-list-name Enter the name of a configured MAC ACL, up to 140 characters.
interface interface Enter the keyword interface then the one of the following keywords and the
interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a port-channel interface, enter the keywords port-channel then the
port-channel ID.
in | out Identify whether ACL is applied on ingress or egress side.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
Access Control Lists (ACL) 217