Users Guide

deny Enter the keyword deny to drop any traffic matching this filter.
permit Enter the keyword permit to forward any traffic matching this filter.
any Enter the keyword any to filter all packets.
host mac-address Enter the keyword host and then enter a MAC address to filter packets with that
host address.
mac-source-
address
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
The MAC ACL supports an inverse mask; therefore, a mask of ff:ff:ff:ff:ff:ff allows
entries that do not match and a mask of 00:00:00:00:00:00 only allows entries
that match exactly.
mac-source-
address-mask
Specify which bits in the MAC address must be matched.
mac-destination-
address
Enter the destination MAC address and mask in nn:nn:nn:nn:nn:nn format.
mac-destination-
address-mask
Specify which bits in the MAC address must be matched.
The MAC ACL supports an inverse mask; therefore, a mask of ff:ff:ff:ff:ff:ff allows
entries that do not match and a mask of 00:00:00:00:00:00 only allows entries
that match exactly.
ethertype
operator
(OPTIONAL) To filter based on protocol type, enter one of the following
Ethertypes:
• ev2 - is the Ethernet II frame format.
• llc - is the IEEE 802.3 frame format.
• snap - is the IEEE 802.3 SNAP frame format.
count (OPTIONAL) Enter the keyword count to count packets the filter processes.
byte (OPTIONAL) Enter the keyword byte to count bytes the filter processes.
log (OPTIONAL, E-Series only) Enter the keyword log to log the packets.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic
that you want to monitor and the ACL in which you are creating the rule is applied
to the monitored interface.
NOTE: For more information, refer to the Flow-based Monitoring section
in the Port Monitoring chapter of the Dell Networking OS Configuration
Guide.
no-drop Enter the keywords no-drop to match only the forwarded packets.
Defaults Not configured.
Command Modes CONFIGURATION-MAC ACCESS LIST-STANDARD
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Added the no-drop parameter. Introduced on the S3048–ON and S4048–ON.
Access Control Lists (ACL) 230