Users Guide

deny udp (for IPv6 ACLs)
Configure a filter to drop user datagram protocol (UDP) packets meeting the filter criteria.
Syntax
deny udp {source address mask | any | host ipv6-address} [operator port [port]]
{destination address | any | host ipv6-address} [operator port [port]] [count
[byte]] [log [interval minutes] [threshold-in-msgs [count]] [monitor]
To remove this filter, you have two choices:
• Use the no seq sequence-number command syntax if you know the filter’s sequence number
• Use the no deny udp {source address mask | any | host ipv6-address}
{destination address | any | host ipv6-address} command
Parameters
log (OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
threshold-in msgs
count
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to
indicate the maximum number of ACL logs that can be generated, exceeding
which the generation of ACL logs is terminated. with the seq, permit, or deny
commands. The threshold range is from 1 to 100.
interval minutes (OPTIONAL) Enter the keyword interval followed by the time period in minutes
at which ACL logs must be generated. The threshold range is from 1 to 10
minutes.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic
that you want to monitor and the ACL in which you are creating the rule is applied
to the monitored interface.
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is five minutes. By default, flow-based monitoring
is not enabled.
Command Modes ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Added support for flow-based monitoring on the S4810, S4820T, S6000, Z9000,
and MXL 10/40GbE Switch IO Module platforms.
9.3(0.0) Added support for logging of ACLs on the S4810, S4820T, Z9000, and MXL
10/40GbE Switch IO Module platforms.
Access Control Lists (ACL) 303