Users Guide

Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of the VRF to clear
information on route dampening corresponding to that VRF
NOTE: You can use this attribute on a specific VRF to remove history
routes corresponding to that VRF. You can also use this attribute to return
the suppressed routes corresponding to a specific VRF to an active state.
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword multicast to
clear the ipv4 multicast routes.
ipv4 unicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword unicast to clear
the ipv4 unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the keyword unicast to clear
the ipv6 unicast routes.
ipv4-address
mask
(OPTIONAL) Enter an IPv4 address in dotted decimal format and the prefix mask in
slash format (/x) to clear dampening information only that BGP neighbor.
ipv6–address
mask
(OPTIONAL) Enter the IPv6 address and the network mask to clear information on
IPv6 route dampening.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information After you enter this command, the software deletes the history routes and returns the suppressed routes
to the Active state.
The clear ip bgp dampening command does not clear the history paths.
Border Gateway Protocol 358