Users Guide

Version Description
7.7.1.0 Introduced on the C-Series.
Usage Information By default, when you create a neighbor/peer group configuration in the Router BGP context, this enables
IPv4/Unicast AFI/SAFI. When you use activate in the new context, the neighbor/peer group enables for
AFI/SAFI.
It is not possible to de-activate a peer from the IPv4 unicast address family.
neighbor add-path
This command allows the specified neighbor/peer group to send/receive multiple path advertisements.
Syntax
neighbor [ip-address | peer-group-name] add-path [send | receive | both] path-
count
Parameters
ip-address (OPTIONAL) Enter the IP address of the neighbor in dotted decimal format.
peer-group-name (OPTIONAL) Enter the name of the peer group.
send Enter the keyword send to indicate that the system sends multiple paths to peers.
receive Enter the keyword receive to indicate that the system accepts multiple paths
from peers.
both Enter the keyword both to indicate that the system sends and accepts multiple
paths from peers.
path-count Enter the number paths supported. The range is from 2 to 64.
Defaults none
Command Modes CONFIGURATION-ROUTER-BGP-ADDRESS FAMILY
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
Related
Commands
• bgp add-path — allow the advertisement of multiple paths for the same address prefix without the
new paths implicitly replacing any previous ones.
Border Gateway Protocol 373