Users Guide

The history paths that the show ip bgp command displays contain only the prefix and the next-hop
information. The next-hop information shows the ip address of the neighbor. It does not show the actual
next-hop details.
The following describes the show ip bgp damp command shown in the following example.
Field Description
Network Displays the network ID to which the route is dampened.
From Displays the IP address of the neighbor advertising the dampened route.
Reuse Displays the hour:minutes:seconds until the dampened route is available.
Path Lists all the ASs the dampened route passed through to reach the destination
network.
Example
Dell# show ip bgp dampened-paths
BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 0
BGP local router ID is 192.168.11.5
Status codes: s suppressed, S stale, d dampened, h history, * valid, > best
Path source: I - internal, a - aggregate, c - confed-external, r -
redistributed
n - network, D - denied, S - stale
Origin codes: i - IGP, e - EGP, ? - incomplete
Network From Reuse Path
d 55.0.0.0/24 172.16.0.2 00:36:23 200
Dell#
show ip bgp dampened-paths
View BGP routes that are dampened (non-active).
S4820T
Syntax
show ip bgp [vrf vrf-name] [ipv4 {multicast | unicast} | ipv6 unicast]
dampened-paths
Parameters
vrf vrf-name (OPTIONAL) Enter the keywords vrf and then the name of the VRF to view routes
that are affected by a specific community list corresponding to that VRF.
ipv4 multicast (OPTIONAL) Enter the keyword ipv4 followed by the keyword multicast to
view information related only to ipv4 multicast routes.
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 followed by the keyword unicast to view
information related only to ipv4 unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the keyword unicast to view
information related only to ipv6 unicast routes.
Command Modes
• EXEC
• EXEC Privilege
Border Gateway Protocol 416