Users Guide

Related
Commands
• set extcommunity rt — set the extended community route origins using the route-map.
show ip bgp ipv4 extcommunity-list
To display the IPv4 routes matching the extended community list name, use this feature.
Syntax
show ip bgp [ipv4 [multicast | unicast] | ipv6 unicast] extcommunity-list name
Parameters
multicast Enter the keyword multicast to display the multicast route information.
unicast Enter the keyword unicast to display the unicast route information.
ipv6 unicast Enter the keywords ipv6 unicast to display the IPv6 unicast route information.
name (OPTIONAL) Enter the name of the extcommunity-list.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the E-Series.
Usage Information
If there is a type or sub-type that is not well-known, it is displayed as:TTSS:XX:YYYY.
Where TT is type, SS is sub-type displayed in hexadecimal format, XX:YYYY is the value divided into 2–
byte and 4-byte values in decimal format. This format is consistent with other vendors.
For example, if the extended community has type 0x04, sub-type 0x05, value 0x20 00 00 00 10 00, it
displays as:0x0405:8192:4096.
Non-transitive extended communities are marked with an asterisk.
Example
Dell#show ip bgp ipv4 multicast extcommunity-list
BGP routing table entry for 192.168.1.0/24, version 2
Paths: (1 available, table Default-IP-Routing-Table.)
Not advertised to any peer
Received from :
Border Gateway Protocol 447