Users Guide

There can be only one odd number of Blocks in the CLI configuration; the other Blocks must be in
factors of 2. For example, a CLI configuration of 5+4+2+1+1 Blocks is not supported; a configuration of
6+4+2+1 Blocks is supported.
The ipv6acl allocation must be a factor of 2.
If allocation values are not entered for the CAM regions, the value is 0.
If you enable BMP, to perform a reload on the chassis to upgrade any configuration changes that have
changed the NVRAM content, use the command reload conditional nvram-cfg-change.
cam-acl-egress
Allocate CAM for egress ACLs.
S4820T
Syntax
cam-acl-egress default | l2acl number ipv4acl number ipv6acl number
Parameters
default Reset egress CAM ACL entries to default settings.
l2acl number Allocate space to each CAM region. The total space allocated must equal 4. The
ipv6acl range must be a factor of 2.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
cam-optimization
Optimize CAM utilization for QoS Entries by minimizing require policy-map CAM space.
S4820T
Syntax
cam-optimization [qos]
Content Addressable Memory (CAM) 459