Users Guide

Usage Information
You can use this command even without enabling DCB.
Example
(Summary)
Dell#show int te 1/1 pfc statistics
Interface TenGigabitEthernet 1/1
Priority Rx XOFF Frames Rx Total Frames Tx Total Frames
-----------------------------------------------------------------
0 0 0 0
1 0 0 0
2 0 0 0
3 0 0 0
4 0 0 0
5 0 0 0
6 0 0 0
7 0 0 0
show stack-unit stack-ports pfc details
Displays the PFC configuration applied to ingress traffic on stacked ports, including PFC Operational mode on each unit with
the configured priorities, link delay, and number of pause packets sent and received.
Syntax
show stack-unit {all | stack-unit} stack-ports {all | port-number} pfc details
Parameters
stack-unit Enter the stack unit.
port-number Enter the port number.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Example
(Summary)
Dell(conf)# show stack-unit all stack-ports all pfc details
stack unit 0 stack-port all
Admin mode is On
Admin is enabled, Priority list is 4-5
Local is enabled, Priority list is 4-5
Link Delay 45556 pause quantum
0 Pause Tx pkts, 0 Pause Rx pkts
stack unit 1 stack-port all
Admin mode is On
Admin is enabled, Priority list is 4-5
Local is enabled, Priority list is 4-5
Link Delay 45556 pause quantum
0 Pause Tx pkts, 0 Pause Rx pkts
ETS Commands
The following ETS commands are supported on the Dell Networking OS.
NOTE
: Before configuring ETS, assign the etsacl space. using the cam-acl l2acl 2 ipv4acl 0 ipv6acl 0 ipv4qos
2 l2qos 0 l2pt 0 ipmacacl 0 vman-qos 0 fcoeacl 2 etsacl 1 iscsi 2 command.
Data Center Bridging (DCB) 481