Users Guide

DCB POLICY Mode
To enable and configure a Data Center Bridging (DCB) input or output policy, use DCB POLICY mode. For more information,
see Data Center Bridging (DCB).
To enter DCB POLICY mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. To enable or configure a DCB input policy, enter the dcb-input command then enter the policy name. To enable or
configure a DCB output policy, enter the dcb-output command then enter the policy name. The prompt changes to
include conf-dcb-in for an input policy or conf-dcb-out for an output policy.
You can return to CONFIGURATION mode by using the exit command.
DHCP Mode
To enable and configure Dynamic Host Configuration Protocol (DHCP), use DHCP mode. For more information, see Dynamic
Host Configuration Protocol (DHCP).
To enter DHCP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the ip dhcp server command. The prompt changes to include config-dhcp.
You can return to CONFIGURATION mode by using the exit command.
DHCP POOL Mode
To create an address pool, use DHCP POOL mode. For more information, see Dynamic Host Configuration Protocol (DHCP).
To enter DHCP POOL mode:
1. Verify that you are logged in to DHCP mode.
2. Enter the pool command then the pool name. The prompt changes to include config-dhcp-pool-name.
You can return to DHCP mode by using the exit command.
ECMP GROUP Mode
To enable or configure traffic distribution monitoring on an ECMP link bundle, use ECMP GROUP mode. For more information,
see ecmp_overview.
To enter ECMP GROUP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the ecmp-group command then enter the ECMP group ID. The prompt changes to include conf-ecmp-group-
ecmp-group-id.
You can return to CONFIGURATION mode by using the exit command.
EIS Mode
To enable or configure Egress Interface Selection (EIS), use EIS mode.
CLI Basics 50