Users Guide

Parameters
dcb-map-name Enter the name of the DCB map.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.3(0.0) Introduced on the S4810 and S6000 platforms.
Usage Information The dcb-map stack-unit all stack-ports all command overwrites any previous DCB maps
applied to stack ports.
show qos dcb-map
Display the DCB parameters configured in a specified DCB map.
Syntax
show qos dcb-map map-name
Parameters
map-name Displays the PFC and ETS parameters configured in the specified map.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.3(0.0) Introduced on the S4810 and S6000 platforms.
9.3(0.0) Introduced on the FC Flex IO module installed in the MXL 10/40GbE Switch.
Usage Information
Use the show qos dcb-map command to display the enhanced transmission selection (ETS) and
priority-based flow control (PFC) parameters used to configure server-facing Ethernet ports. S5000
Ethernet ports are DCBx-enabled by default.
The following table describes the show qos dcb-map output shown in the example below.
Field Description
State Complete: All mandatory DCB parameters are correctly configured. In progress:
The DCB map configuration is not complete. Some mandatory parameters are not
configured.
Data Center Bridging (DCB) 506