Users Guide

PORT-CHANNEL FAILOVER-GROUP Mode
To configure shared LAG state tracking, use PORT-CHANNEL FAILOVER-GROUP mode. For more information, see Port
Channel Commands.
To enter PORT-CHANNEL FAILOVER-GROUP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the port-channel failover-group command. The prompt changes to include conf-po-failover-grp.
You can return to CONFIGURATION mode by using the exit command.
PREFIX-LIST Mode
To configure a prefix list, use PREFIX-LIST mode.
To enter PREFIX-LIST mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the ip prefix-list command and the name for the prefix list. The prompt changes to include conf-nprefixl.
You can return to CONFIGURATION mode by using the exit command.
PRIORITY GROUP Mode
To create an ETS priority group, use PRIORITY GROUP mode. For more information, see ETS Commands.
To enter PRIORITY GROUP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the priority-group command, and then the group name. The prompt changes to include conf-pg.
You can return to CONFIGURATION mode by using the exit command.
PROTOCOL GVRP Mode
To enable and configure GARP VLAN Registration Protocol (GVRP), use PROTOCOL GVRP mode. For more information, see
GARP VLAN Registration (GVRP).
To enter PROTOCOL GVRP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the protocol gvrp command. The prompt changes to include config-gvrp.
You can return to CONFIGURATION mode by using the exit command.
QOS POLICY Mode
To configure ETS bandwidth allocation and scheduling for priority traffic, use QOS POLICY mode. For more information, see
ETS Commands.
To enter QOS POLICY mode:
1. Verify that you are logged in to CONFIGURATION mode.
CLI Basics 55