Users Guide

Parameters
access-list
Enter the name of the extended ACL (16 characters maximum).
Defaults Not configured
Command Modes INTERFACE (conf-if-interface-slot/port)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
7.6.1.0 Introduced on E-Series.
Usage Information The access list accepted is an extended ACL. To block IGMP reports from hosts, on a per-interface basis
based on the group address and source address that you specify in the access list, use this feature.
ip igmp group-join-limit
To limit the number of IGMP groups that can be joined in a second, use this feature.
Z9500
Syntax
ip igmp group-join-limit number
Parameters
number Enter the number of IGMP groups permitted to join in a second. The range is from
1 to 10000.
Defaults none
Command Modes CONFIGURATION (conf-if-interface-slot/port)
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Internet Group Management Protocol (IGMP) 658