Users Guide

clear ip igmp snooping groups
Clear snooping entries from the group cache table.
S4820T
Syntax
clear ip igmp snooping groups [group-address interface | interface]
Parameters
group-address (OPTIONAL) Enter the IP multicast group address in dotted decimal format.
interface interface Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
• For a port channel interface, enter the keywords port-channel then a
number.
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on S-Series and Z–Series.
Usage Information IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield results.
debug ip igmp snooping
Enable debugging of IGMP snooping packets on interfaces and groups.
S4820T
Syntax
debug ip igmp snooping [group address | interface]
• To disable debugging of IGMP snooping, use the no debug ip igmp snooping [group
address | interface] command.
• To disable all debugging, use the undebug all command.
Parameters
snooping Enter the keyword snooping to enable debugging of IGMP snooping.
Internet Group Management Protocol (IGMP) 671