Users Guide

Related
Commands
• show interfaces dampening — display interface dampening information.
• dampening — configure dampening on an interface.
dampening
Configure dampening on an interface.
Syntax
dampening [[[[half-life] [reuse-threshold]] [suppress-threshold]] [max-
suppress-time]]
Parameters
half-life Enter the number of seconds after which the penalty is decreased. The penalty
decreases half after the half-life period expires. The range is from 1 to 30 seconds.
The default is 5 seconds.
reuse-threshold Enter a number as the reuse threshold, the penalty value below which the
interface state is changed to “up”. The range is from 1 to 20000. The default is
750.
suppress-
threshold
Enter a number as the suppress threshold, the penalty value above which the
interface state is changed to “error disabled”. The range is from 1 to 20000. The
default is 2500.
max-suppress-
time
Enter the maximum number for which a route can be suppressed. The default is
four times the half-life value. The range is from 1 to 86400. The default is 20
seconds.
Defaults Disabled.
Command Modes INTERFACE (conf-if-)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
Interfaces 685