Users Guide

Version Description
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage Information This command is found on the Management interface only.
Related
Commands
• interface ManagementEthernet — configure the Management port on the system (either the Primary
or Standby RPM).
• duplex (10/100 Interfaces) — configure duplex mode on physical interfaces with the speed set to
10/100.
• management route — configure a static route that points to the Management interface or a
forwarding router.
stack-unit portmode
Split a single 40G port into four 10G ports.
Syntax
stack-unit stack-unit port number portmode quad
Parameters
stack-unit Enter the stack member unit identifier of the stack member to reset.
number Enter the port number of the port to be split. Enter one of the following port
numbers: 48, 52, 56, or 60.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.7(0.0) Added support for dynamically fanning-out of interfaces on S6000. Introduced on
the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
Usage Information You cannot use the split ports as stack-link to stack a system.
The port must be in a default configuration before it can be split. As the 40G port is lost in the
configuration when the port is split, ensure that you remove the port from other L2/L3 feature
configurations.
The system must be reloaded after issuing the CLI for the change to take effect.
Interfaces 749