Users Guide

Example
Dell# show interfaces port-channel 1 brief
LAG Mode Status Uptime Ports
1 L2 up 00:00:08 Te 3/1 (Up) *
Te 3/2 (Down)
Te 3/3 (Up)
Dell#
Related
Commands
• show lacp — display the LACP matrix.
show port-channel-flow
Display an egress port in a given port-channel flow.
Syntax
show port-channel-flow outgoing-port-channel number incoming-interface
interface {source-ip address destination-ip address} | {source-port number
destination-port number} | {source-mac address destination-mac address {vlan
vlanid | ether-type}}
Parameters
outgoing-port-
channel number
Enter the keywords outgoing-port-channel then the number of the port
channel to display flow information.
• For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to
128.
incoming-
interface interface
Enter the keywords incoming-interface then the interface type and the
interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
source-ip address Enter the keywords source-ip then the IP source address in IP address format.
destination-ip
address
Enter the keywords destination-ip then the IP destination address in IP
address format.
source-port
number
Enter the keywords source-port then the source port number. The range is
from 1 to 65536. The default is None.
destination-port
number
Enter the keywords destination-port then the destination port number. The
range is from 1 to 65536. The default is None.
source-mac
address
Enter the keywords source-mac then the MAC source address in the
nn:nn:nn:nn:nn:nn format.
destination-mac
address
Enter the keywords destination-mac then the MAC destination address in the
nn:nn:nn:nn:nn:nn format.
vlan vlan-id Enter the keywords vlan then the VLAN-id. The range is from 0 to 4094.
ether-type Enter the keywords ether-type in the XX:XX format.
Command Modes EXEC
Interfaces 766