Users Guide

• show arp
• show arp retries
• show hosts
• show ip cam linecard
• show ip cam stack-unit
• show ip fib stack-unit
• show ip flow
• show ip interface
• show ip management-route
• show ip protocols
• show ip route
• show ip route list
• show ip route summary
• show ip traffic
• show tcp statistics
arp
To associate an IP address with a MAC address in the switch, use address resolution protocol (ARP).
S4820T
Syntax
arp [vrf vrf-name] ip-address mac-address interface
To remove an ARP address, use the no arp ip-address command.
Parameters
vrf vrf-name Enter a VRF name to configure an ARP entry for that VRF. Use the VRF option after
the keyword arp to configure a static arp on that particular VRF.
ip-address Enter an IP address in dotted decimal format.
mac-address Enter a MAC address in nnnn.nnnn.nnnn format.
interface (OPTIONAL) Enter any of the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
slot/port information.
• For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-channel then a
number.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
IPv4 Routing 783