Users Guide

to the following example). ARP packets (arp) and Ether-type (ether-type) are also not supported in the
access-group option. The entire rule is skipped to compose the filter.
The access-group option pertains to:
• IP protocol number: from 0 to 255
• Internet control message protocol (icmp) but not the ICMP message type (from 0 to 255)
• Any internet protocol (ip)
• Transmission Control Protocol (tcp) but not on the rst, syn, or urg bits
• User Datagram Protocol (udp)
In the case of ambiguous access control list rules, the debug ip packet access-control command
is disabled. A message appears identifying the error (refer to the Example below).
Example (Error
Messages)
Dell# debug ip packet access-group test
%Error: port operator GT not supported in access-list debug
%Error: port operator LT not supported in access-list debug
%Error: port operator RANGE not supported in access-list debug
%Error: port operator NEQ not supported in access-list debug
Dell#00:10:45: %RPM0-P:CP
%IPMGR-3-DEBUG_IP_PACKET_ACL_AMBIGUOUS_EXP: Ambiguous rules not
supported in access-list debug, access-list debugging is turned off
Dell#
ip address
Assign a primary and secondary IP address to the interface.
S4820T
Syntax
ip address ip-address mask [secondary]
To delete an IP address from an interface, use the no ip address [ip-address] command.
Parameters
ip-address Enter an IP address in dotted decimal format.
mask Enter the mask of the IP address in slash prefix format (for example, /24).
secondary (OPTIONAL) Enter the keyword secondary to designate the IP address as the
secondary address.
Defaults Not configured.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
IPv4 Routing 799