Users Guide

• For a port channel interface, enter the keywords port-channel then a
number.
• For a Null interface, enter the keyword null then the Null interface number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel then the tunnel interface
number. The range is from 1 to 16383.
If you configure a static IPv6 route using an egress interface and enter the ping
command to reach the destination IPv6 address, the ping operation may not
work. Configure the IPv6 route using a next-hop IPv6 address in order for the ping
command to detect the destination address.
interface ip-
address
Enter the keyword interface then the IP address.
distance (OPTIONAL) Enter the value of the distance metric assigned to the route. The
range is from 1 to 255.
permanent (OPTIONAL) Enter the keyword permanent to specify that the route must not be
removed even if the interface assigned to that route goes down. The route must
be currently active to be installed in the routing table. If you disable the interface,
the route is removed from the routing table.
tag tag-value (OPTIONAL) Enter the keyword tag then a number to assign to the route. The
range is from 1 to 4294967295.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF. Use this VRF option after
the next hop to specify which VRF the next hop belongs to. This setting is used in
route leaking cases. See “R”oute Leaking VRFs” in the Virtual Routing and
Forwarding (VRF) section of the Configuration guide.
weight weight-
value
Enter the keyword weight followed by a weight value. The range is from 0 to
255.
NOTE: Weight for a static route can be added only for the destination
address and not for the route pointing to destination a interface.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Included the weighted parameter to support weighted ECMP feature.
9.4.(0.0) Added support for VRF.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.2.(0.0) Added support for tunnel interface type.
IPv4 Routing 815