Users Guide

Command Modes
CONFIGURATION
Command History
Version Description
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.3(0.0) Introduced on the S4810, S4820T, S6000, and Z9000 platforms.
Usage Information You can configure the amount of time for which the device must wait before it attempts to establish a
TCP connection. Using this capability, you can limit the wait times for TCP connection requests. Upon
responding to the initial SYN packet that requests a connection to the router for a specific service (such
as SSH or BGP) with a SYN ACK, the router waits for a period of time for the ACK packet to be sent from
the requesting host that will establish the TCP connection.
show ip tcp initial-time
Displays the interval that you configured for the device to wait before the TCP connection is attempted to be established.
Syntax
show ip tcp initial-time
Command Modes
EXEC
EXEC Privilege
Command History
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.3(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL platforms.
ip unreachables
Enable the generation of internet control message protocol (ICMP) unreachable messages.
S4820T
Syntax
ip unreachables
To disable the generation of ICMP messages, use the no ip unreachables command.
Defaults Disabled.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
IPv4 Routing 818