Users Guide

ip-address mask
[longer-prefix]
(OPTIONAL) Enter the IP address and mask of a route to CAM entries for that
route only. Enter the keyword longer-prefixes to view routes with a common
prefix.
index index-
number
(OPTIONAL) Enter the keyword index then the CAM index number. The range
depends on CAM size.
summary (OPTIONAL) Enter the keyword summary to view a table listing route prefixes and
the total number of routes that can be entered into the CAM.
vrf instance (OPTIONAL) E-Series Only: Enter the keyword vrf then the VRF instance name to
show CAM information as it applies to that VRF instance.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.1.1.2 Introduced on the E-Series E600i.
8.1.1.0 Introduced on the E-Series.
7.9.1.0 Introduced VRF on the E-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage Information The following describes the show ip cam command shown in the following example.
Field Description
Index Displays the CAM index number of the entry.
Destination Displays the destination route of the index.
EC Displays the number of equal cost multipaths (ECMP) available for the default
route for non-Jumbo line cards. For Jumbo line cards, displays 0,1 when ECMP is
more than eight.
CG Displays 0.
V Displays a 1 if the entry is valid and a 0 if the entry is for a line card with Catalog
number beginning with LC-EF.
C Displays the CPU bit. 1 indicates that a packet hitting this entry is forwarded to the
CP or RP2, depending on Egress port.
Next-Hop Displays the next hop IP address of the entry.
VId Displays the VLAN ID. If the entry is 0, the entry is not part of a VLAN.
Mac Addr Displays the next-hop router’s MAC address.
IPv4 Routing 829