Users Guide

Control and Monitoring

This section contains command information to configure and monitor the system, including Telnet, file transfer protocol (FTP),

and trivial file transfer protocol (TFTP).

asf-mode

Enable alternate store and forward (ASF) mode and forward packets as soon as a threshold is reached.

Syntax

asf-mode stack-unit {unit-id | all} queue size

To return to standard Store and Forward mode, use the no asf-mode command.

Parameters

unit-id Enter the stack member unit identifier of the stack member to reset. The S4820T range is from 0 to 11.

NOTE: The S4820T commands accept Unit ID numbers from 0 to 11, though S4820T supports

stacking of up to six units.

queue size Enter the queue size of the stack member. The range is from 0 to 15.

unit-id Enter the stack member unit identifier of the stack member to reset. The S4820T range is from 0 to 11.

NOTE: The S4820T commands accept Unit ID numbers from 0 to 11, though S4820T supports

stacking of up to six units.

queue size Enter the queue size of the stack member. The range is from 0 to 15.

Defaults

Not configured

Command Modes

CONFIGURATION

Control and Monitoring 87