Users Guide

gigabitethernet 0/0 is up, line protocol is down
Hardware is DellEth, address is 90:b1:1c:f4:9a:fa
Current address is 90:b1:1c:f4:9a:fa
Pluggable media present, SFP type is 1GBASE
……………………
LineSpeed 1000 Mbit
Dell#show interfaces tengigabitethernet 0/8
TenGigabitEthernet 0/0 is up, line protocol is up
Hardware is DellEth, address is 90:b1:1c:f4:9a:fa
Current address is 90:b1:1c:f4:9a:fa
Pluggable media present, QSFP type is 4x10GBASE-CR1-3M
……..
LineSpeed 10000 Mbit
The show inventory command shows the following output:
NOTE: In the following show inventory media command output, the port numbers 1, 2, 3, 5, 6, and 7 ports are actually
inactive. However, Dell Networking OS still shows that optical cables are inserted into these ports. This is a software
limitation for this release.
Dell# show inventory media
Slot Port Type Media Serial Number
-------------------------------------------------------------------
0 0 SFP+ 10GBASE-SX APF12420031B3P
0 1 SFP+ 10GBASE-SX APF12420031B3P
0 2 SFP+ 10GBASE-SX APF12420031B3P
0 3 SFP+ 10GBASE-SX APF12420031B3P
0 4 SFP 10GBASE-SX APF12420031B3P
0 5 SFP 10GBASE-SX APF12420031B3P
0 6 SFP 10GBASE-SX APF12420031B3P
0 7 SFP 10GBASE-SX APF12420031B3P
0 8 QSFP 4x10GBASE-CR1-3M APF12420031B3P
0 9 QSFP 4x10GBASE-CR1-3M APF12420031B3P
0 10 QSFP 4x10GBASE-CR1-3M APF12420031B3P
0 11 QSFP 4x10GBASE-CR1-3M APF12420031B3P
0 12 QSFP 40GBASE-SR4
Configuring wavelength for 10–Gigabit SFP+
optics
You can set the wavelength for tunable 10–Gigabit SFP+ optics using the wavelength command. To set the wavelength,
follow these steps:
• Enter the interface mode and set the wavelength.
INTERFACE mode
wavelength 1529.0
The wavelength range is from 1528.3 nm to 1568.77nm.
• Verify configuration changes.
INTERFACE mode
show config
Link Dampening
Interface state changes occur when interfaces are administratively brought up or down or if an interface state changes.
Every time an interface changes a state or flaps, routing protocols are notified of the status of the routes that are affected by
the change in state. These protocols go through the momentous task of re-converging. Flapping; therefore, puts the status of
entire network at risk of transient loops and black holes.
Interfaces 398