Owners Manual

Ranges for the CAM profiles are from 1 to 10, except for the ipv6acl profile which
is from 0 to 10. The ipv6acl allocation must be a factor of 2 (2, 4, 6, 8, 10).
If you enabled BMP, to perform a reload on the chassis to upgrade any
configuration changes that have changed the NVRAM content, use the reload
conditional nvram-cfg-change command.
cam-acl-vlan
Specify the number of VFP blocks allocated to OpenFlow.
S4820T
Syntax
cam-acl-vlan vlanopenflow {0|1} vlaniscsi {0|1}
Defaults Disabled.
Parameters
vlanopenflow Enter the number 1 to allocate VFP blocks and enable
OpenFlow.
(Default) Enter the number 0 to disable OpenFlow.
vlaniscsi Enter the number 1 to allocate VFP blocks for iSCSI.
Enter the number 0 to disable iSCSI CAM allocation.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.1.
(0.0)
Introduced on S4810.
Version
8.3.19.0
Introduced on the S4820T.
Usage
Information
Reboot the switch after changing the parameter values for changes to take effect.
For platform-specific instructions about using this command, refer to the SDN
chapter in the Dell Networking OS Configuration Guide.
Control and Monitoring
105