Owners Manual

Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
access-list Enter the name of an extended access list. Maximum 16
characters.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the C-Series and S-Series.
7.6.1.0 Introduced
Usage
Information
The access name is an extended IP access list that denies PIM register packets to
RP at the source DR based on the multicast and group addresses. Do not enter this
command before creating the access-list.
ip pim rp-address
Configure a static PIM rendezvous point (RP) address for a group or access-list.
S4820T
Syntax
ip pim [vrf vrf-name] rp-address address {group-address group-
address mask} [override]
To remove an RP address, use the no ip pim [vrf vrf-name] rp-address
address {group-address group-address mask} [override] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF.
1354
PIM-Sparse Mode (PIM-SM)