Owners Manual

ip pim rp-candidate
To send out a Candidate-RP-Advertisement message to the bootstrap (BS) router or define group
prefixes that are defined with the RP address to PIM BSR, configure a PIM router.
Syntax
ip pim [vrf vrf-name] rp-candidate {interface [priority]}
To return to the default value, use the no ip pim [vrf vrf-name] rp-
candidate {interface [priority]} command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of
the VRF.
NOTE: Applies to specific VRF if input is provided, else
applies to Default VRF.
interface Enter the following keywords and slot/port or number
information:
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
priority (OPTIONAL) Enter the priority used in Bootstrap election
process. The range is zero (0) to 255. The default is 192.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
1356
PIM-Sparse Mode (PIM-SM)