Owners Manual

Version Description
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage
Information
If a local-as is configured, BGP does not allow for the configuration of BGP
confederation. Similarly, if BGP confederation is configured, then BGP does not
allow the configuration of local-as.
This command automatically restarts the neighbor session for the configuration to
take effect.
Related
Commands
bgp four-octet-as-support — enables 4-byte support for the BGP process.
neighbor maximum-prefix
Control the number of network prefixes received.
S4820T
Syntax
neighbor {ip-address | peer-group-name} maximum-prefix maximum
[threshold] [warning-only]
To return to the default values, use the no neighbor {ip-address | peer-
group-name
} maximum-prefix maximum command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group.
maximum Enter a number as the maximum number of prefixes allowed
for this BGP router. The range is from 1 to 4294967295.
threshold (OPTIONAL) Enter a number to be used as a percentage of
the maximum value. When the number of prefixes reaches
this percentage of the maximum value, the E-Series software
sends a message. The range is from 1 to 100 percent. The
default is 75.
warning-only (OPTIONAL) Enter the keyword warning-only to set the
router to send a log message when the maximum value is
Border Gateway Protocol
441