Owners Manual

Defaults PFC mode is on.
Command
Modes
DCB INPUT POLICY
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4.(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
By applying a DCB input policy with PFC enabled, you enable PFC operation on
ingress port traffic. To achieve complete lossless handling of traffic, also enable
PFC on all DCB egress ports or configure the dot1p priority-queue assignment of
PFC priorities to lossless queues (refer to pfc no-drop queues).
To disable PFC operation on an interface, enter the no pfc mode on command in
DCB Input Policy Configuration mode. PFC is enabled and disabled as global DCB
operation is enabled (
dcb-enable) or disabled (no dcb-enable).
You cannot enable PFC and link-level flow control at the same time on an
interface.
pfc no-drop queues
Configure the port queues that still function as no-drop queues for lossless traffic.
Syntax
pfc no-drop queues queue-range
To remove the no-drop port queues, use the no pfc no-drop queues
command.
Parameters
queue-range Enter the queue range. Separate the queue values with a
comma; specify a priority range with a dash; for example,
pfc no-drop queues 1,3 or pfc no-drop queues 7
or pfc no-drop queues 0,7. The range is from 0 to 3.
Data Center Bridging (DCB)
545